Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Initialising ...
Sun, Haomin; Kunugi, Tomoaki*; Yokomine, Takehiko*; Shen, X.*; Hibiki, Takashi*
Experimental Thermal and Fluid Science, 154, p.111171_1 - 111171_24, 2024/05
Times Cited Count：0Facilities Preservation Management Section, Safety Administration Department
JAEA-Review 2023-035, 218 Pages, 2024/03
JAEA-Review-2023-035.pdf:8.47MB
In September 2022, Japan Atomic Energy Agency (JAEA) published the 2021 Environmental Report concerning the activities of FY 2021 under "Act on the Promotion of Business Activities with Environmental Consideration by Specified Corporations, etc., by Facilitating Access to Environmental Information, and Other Measures". This report has been edited to show detailed environmental performance data in FY 2021 as the base of the 2021 Environmental Report. This report would not only ensure traceability of the data in order to enhance the reliability of the environmental report, but also make useful measures for promoting activities of environmental considerations in JAEA.
Togawa, Orihiko; Hokama, Tomonori; Hiraoka, Hirokazu; Saito, Shota
JAEA-Research 2023-011, 78 Pages, 2024/03
JAEA-Research-2023-011.pdf:2.09MB
When radionuclides are released into the atmospheric environment at a nuclear emergency, protective measures such as evacuation and temporal relocation are carried out using motor vehicles such as private cars and buses to reduce radiation exposure to residents. To confirm conditions of contamination for the evacuated/relocated residents and the used motor vehicles, contamination inspection is conducted in the middle of the route from border areas of Nuclear Emergency Planning Zone to evacuation shelters. In the present inspection in Japan, a value of OIL4 = 40,000 cpm is used as decontamination criteria. For the details and derivation methods of the value, however, no official documents are found which give systematically detailed descriptions and explanation. It is also recognized that even few experts on nuclear emergencies can explain these subjects in detail as a whole. In order to explain scientifically and technically the OIL4 value of decontamination criteria used in contamination inspection in Japan, this report aims at investigating and estimating the deviation methods of OIL4, and examining and considering these results. To achieve the objectives, we show the bases for decontamination criteria, and investigate and estimate the derivation methods for limits of a surface contamination density corresponding to the generic criteria for each exposure pathway. Moreover, we give the OIL4 value some consideration and suggestions from a viewpoint of positioning and feature of OIL4 in Japan, and cautionary points at revising the value.
Project Promotion Department; Radioactive Wastes Disposal Center
JAEA-Review 2023-037, 162 Pages, 2024/02
JAEA-Review-2023-037.pdf:2.66MB
For near surface disposal of radioactive wastes generated from research, industrial and medical facilities, Japan Atomic Energy Agency has discussed methods for corresponding to the technical standards on confirmation related to waste disposal, etc. From FY2022, we have established Waste Standards Committee and interim Waste Acceptance Criteria, Waste Package Confirmation Procedure, etc. have been considered. In FY2022, Waste Package Confirmation Procedures of solidified liquid waste and cement filled waste and related standards were discussed. In addition, issues of preparation of Waste Package Confirmation Procedure and rational treatment method for decommissioning wastes were considered. This annual report summarizes the results of discussion in FY2022.
Mohamad, A. B.; Udagawa, Yutaka
Nuclear Technology, 210(2), p.245 - 260, 2024/02
Times Cited Count：1 Percentile：68.31(Nuclear Science & Technology)Taniguchi, Yoshinori; Mihara, Takeshi; Kakiuchi, Kazuo; Udagawa, Yutaka
Annals of Nuclear Energy, 195, p.110144_1 - 110144_11, 2024/01
Times Cited Count：0 Percentile：0.01(Nuclear Science & Technology)
NiShizuma, Toshiyuki*; Omer, M.; Hayakawa, Takehito*; Minato, Futoshi*; Matsuba, Shunya*; Miyamoto, Shuji*; Shimizu, Noritaka*; Utsuno, Yutaka
Physical Review C, 109(1), p.014302_1 - 014302_7, 2024/01
Times Cited Count：0 Percentile：0.19(Physics, Nuclear)Suzuki, Seiya; Nemoto, Yoshihiro*; Shiiki, Natsumi*; Nakayama, Yoshiko*; Takeguchi, Masaki*
Annalen der Physik, 535(9), p.2300122_1 - 2300122_12, 2023/09
Times Cited Count：0 Percentile：0(Physics, Multidisciplinary)Sun, Haomin; Kunugi, Tomoaki*; Yokomine, Takehiko*; Shen, X.*; Hibiki, Takashi*
International Journal of Heat and Mass Transfer, 211, p.124214_1 - 124214_17, 2023/09
Times Cited Count：2 Percentile：53.66(Thermodynamics)Esser, S. P.*; Rahlff, J.*; Zhao, W.*; Predl, M.*; Plewka, J.*; Sures, K.*; Wimmer, F.*; Lee, J.*; Adam, P. S.*; McGonigle, J.*; et al.
Nature Microbiology (Internet), 8(9), p.1619 - 1633, 2023/09
Times Cited Count：2 Percentile：75.4(Microbiology)Pla
ais, A.*; Bouly, F.*; Yee-Rendon, B.
Proceedings of 14th International Particle Accelerator Conference (IPAC 23) (Internet), p.4097 - 4100, 2023/09
Reliability in high power hadron accelerators is a major issue, particularly for Accelerator Driven Systems (ADS). For example, the Japan Atomic Energy Agency (JAEA) ADS maximum frequency of beam trips longer than 5 min was set to 42 per year. A significant number of breakdowns are caused by the failure of accelerating cavities or by their associated systems. Hence, we studied how these can be effectively reduced. To this end, we developed the numerical tool LightWin that aims to determine the compensation settings for any superconducting (SC) linac automatically and systematically. This tool has been successfully used for the MYRRHA SC linac. In this work, we applied LightWin to compensate for several failure scenarios involving the last section of the JAEA ADS linac and compared the associated retuned settings and beam performance to those found in a previous study with TraceWin.
sp
HRLSawada, Atsushi; Sakamoto, Kazuhiko*; Watahiki, Takanori*; Imai, Hisashi*
SKB P-17-06, 154 Pages, 2023/08
Omer, M.; Shizuma, Toshiyuki*; Koizumi, Mitsuo; Taira, Yoshitaka*; Zen, H.*; Ogaki, Hideaki*; Hajima, Ryoichi
UVSOR-50, P. 37, 2023/08
no abstracts in English
Sakai, Akihiro
Dekomisshoningu Giho, (64), p.24 - 33, 2023/05
Japan Atomic Energy Agency (JAEA) has proceeded with the project of near surface disposal of radioactive waste generated from research facilities, etc. as the implementing body. On the other hand, Nuclear Regulation Authority (NRA) has established the safety regulations and standards for the operation of the disposal facilities. This report outlines the disposal project of JAEA and the development of the regulations and standards for the disposal by NRA.
rays from a neutron-induced 
-wave resonance of 
XeOkudaira, Takuya*; Tani, Yuika*; Endo, Shunsuke; Doskow, J.*; Fujioka, Hiroyuki*; Hirota, Katsuya*; Kameda, Kento*; Kimura, Atsushi; Kitaguchi, Masaaki*; Luxnat, M.*; et al.
Physical Review C, 107(5), p.054602_1 - 054602_7, 2023/05
Times Cited Count：2 Percentile：83.53(Physics, Nuclear)no abstracts in English
Yee-Rendon, B.; Kondo, Yasuhiro; Tamura, Jun; Maekawa, Fujio; Meigo, Shinichiro
Proceedings of 14th International Particle Accelerator Conference (IPAC 23) (Internet), p.1591 - 1593, 2023/05
The Japan Atomic Energy Agency (JAEA) is designing a 30 MW continuous wave (cw) superconducting proton linear accelerator (linac) for the Accelerator Driven System (ADS) proposal. The JAEA-ADS linacs ion source must provide a proton beam over 20 mA with an energy of 35 keV and a normalized rms emittance of less than 0.1 
mm mrad. As the extraction system determines the beam properties and quality, systematic optimizations on the geometry and input values of the extraction system design were conducted using the AXCEL-INP 2-D simulation program to satisfy the goal requirements. This work describes the extraction system design and reports the beam dynamics results of the first study for the proton source of the JAEA-ADS linac.
Sakai, Akihiro
Dai-33-Kai Genshiryoku Shisetsu Dekomisshoningu Gijutsu Koza Tekisuto, p.31 - 63, 2023/02
The Japan Atomic Energy Agency (JAEA) is promoting the project for concrete-vault disposal and landfill-type disposal of radioactive waste generated from research facilities, etc. This report introduces current status of technical development for JAEA's disposal project as following items; (1) kinds of research facilities and characteristics of radioactivity inventory of the waste, (2) the structures of the disposal facilities which JAEA conceptually designed, (3) development of waste acceptance criteria for major radioactive waste for the JAEA disposal facilities, (4) the concept of the criteria for disposal of uranium bearing waste, that has been established in 2021.
Yee-Rendon, B.; Kondo, Yasuhiro; Tamura, Jun; Nakano, Keita; Maekawa, Fujio; Meigo, Shinichiro
Proceedings of 19th Annual Meeting of Particle Accelerator Society of Japan (Internet), p.179 - 183, 2023/01
The Japan Atomic Energy Agency accelerator-driven subcritical system (JAEA-ADS) pursues the reduction of nuclear waste by transmuting minor actinides. JAEA-ADS project drives a 30-MW proton beam to a lead-bismuth eutectic (LBE) spallation target to produce neutrons for a subcritical core reactor. To this end, the JAEA-ADS beam transport (BT) must provide a suitable beam profile and stable beam power to the beam window of the spallation target to avoid high-thermal stress in the components, such as the beam window. The beam transport was optimized by tracking a large number of macroparticles to mitigate the beam loss, performance with high stability in the presence of errors, and fulfill the length requirement on the transport. This work presents beam transport design and beam dynamics research for the JAEA-ADS project.
Matsuyama, Tsugufumi*; Nakae, Masanori*; Murakami, Masashi; Yoshida, Yukihiko; Machida, Masahiko; Tsuji, Koichi*
Spectrochimica Acta, Part B, 199, p.106593_1 - 106593_6, 2023/01
Times Cited Count：2 Percentile：43.32(Spectroscopy)Watanabe, Seiya*; Kawahara, Jun*; Aoki, Takayuki*; Sugihara, Kenta; Takase, Shinsuke*; Moriguchi, Shuji*; Hashimoto, Hirotada*
Engineering Applications of Computational Fluid Mechanics, 17(1), p.2211143_1 - 2211143_23, 2023/00
Times Cited Count：1 Percentile：56.82(Engineering, Multidisciplinary)In tsunami inundations or slope disasters of heavy rain, a lot of floating debris or driftwood logs are included in the flows. The damage to structures from solid body impacts is more severe than the damage from the water pressure. In order to study free-surface flows that include floating debris, developing a high-accurate simulation code of free-surface flows with high performance for large-scale computations is desired. We propose the single-phase free-surface flow model based on the cumulant lattice Boltzmann method coupled with a particle-based rigid body simulation. The discrete element method calculates the contact interaction between solids. An octree-based AMR (Adaptive Mesh Refinement) method is introduced to improve computational accuracy and time-to-solution. High-resolution grids are assigned near the free surfaces and solid boundaries. We conducted two kinds of tsunami flow experiments in the 15 and 70 m water tanks at Hachinohe Institute of Technology and Kobe University to validate the accuracy of the proposed model. The simulation results have shown good agreement with the experiments for the drifting speed, the number of trapped wood pieces, and the stacked angles.
